2015 Nissan Sentra Owner’s Manual — Battery replacement

CAUTION

Be careful not to allow children to swallow the battery or removed parts.

Keyfob (if so equipped)

Replace the battery in the keyfob as follows:

1. Remove the screw A .
2. Insert a small screwdriver into the slit of the corner B and twist it to separate the upper part from the lower part. Use a cloth to protect the casing.
3. Replace the battery with a new one.

• Do not touch the internal circuit and electric terminals as doing so could cause a malfunction.
• Make sure that the + side faces the bottom of the case C .

Recommended battery: CR1620 or equivalent.

1. Close the lid and install the screw securely.
2. Operate the buttons to check its operation.

See a NISSAN dealer if you need assistance for replacement.

If the battery is removed for any reason other than replacement, perform step 5.

• An improperly disposed battery can hurt the environment. Always confirm local regulations for battery disposal.
• The keyfob is water-resistant; however, if it does get wet, immediately wipe completely dry.
• The operational range of the keyfob extends to approximately 33 ft (10 m) from the vehicle. This range may vary with conditions.

Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.

FCC Notice: For USA: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For Canada: This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

NISSAN Intelligent Key® (if so equipped)

Replace the battery in the Intelligent Key as follows:

1. Remove the mechanical key from the Intelligent Key.
2. Insert a small screwdriver A into the slit B of the corner and twist it to separate the upper part from the lower part. Use a cloth to protect the casing.
3. Replace the battery with a new one.

Recommended battery: CR2025 or equivalent.

• Do not touch the internal circuit and electric terminals as doing so could cause a malfunction.
• Hold the battery by the edges. Holding the battery across the contact points will seriously deplete the storage capacity.
• Make sure that the + side faces the bottom of the case.

1. Close the lid securely as illustrated C D .
2. Operate the buttons to check the operation.

See a NISSAN dealer if you need assistance for replacement.

FCC Notice: For USA: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For Canada: This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.